Small motorized sprayer troubleshooting

1. Can't start or start hard

The reason is as follows: 1 The fuel tank is oil-free, and fuel can be added. 2 The oil passages are not smooth and the oil passages should be cleaned. 3 The fuel is dirty and the oil contains water. Replace the fuel. 4 Into the cylinder too much oil, remove the spark plug a few revolutions and dry the spark plug. 5 Spark plugs do not flash over, excessive carbon deposits or breakdown of insulators should remove coke or renew insulators. 6 The spark plug and platinum gap are not properly adjusted and should be readjusted. 7 Capacitor breakdown, high-voltage wire breakage or detachment, high-voltage coil breakdown, etc., must be repaired and updated. 8 There is oil on the white gold or burn out, remove the oil or burn the burned parts. 9 If the spark plug is not tightened, the crankcase leaks, and the cylinder mat is burned out, the relevant parts should be fastened or the cylinder head gasket replaced. 10 The self-tightening oil seals on both sides of the crankcase are seriously worn and should be replaced. 10 The main air valve is not open and can be opened.

2. Can start but not enough power

There are the following reasons: (1) Insufficient oil supply, main volume hole plugging, air filter plugging, etc., should be cleaned and dredged. 2 If the platinum gap is too small or the ignition time is too early, adjustment should be made. (3) Excessive carbon deposition in the combustion chamber causes the mixture to ignite (characteristically, the body temperature is too high) and the coke should be removed. 4 The cylinder liner, piston and piston ring are seriously worn and should be replaced with new ones. 5 Mix the oil too thin and increase the contrast.

3. The engine is not running smoothly

The reasons are as follows: 1 The main components are worn out, and the knocking phenomenon occurs during the movement. Replace the components. 2 Ignition time is too early and there is a phenomenon of tempering. Check and adjust. 3 Platinum wear or loose, should be updated or fastened. 4 There is water in the float chamber or oil is deposited, causing unstable operation and cleaning.

4. Sudden flameout during operation

The reasons are: 1 After the fuel is burned, it should be refueled. 2 high-voltage line off, can be connected. 3 throttle control mechanism to remove, should be repaired. 4 The spark plug is broken and must be replaced.

5. Pesticide injection is not atomized

The reasons are: 1 low speed, it should be accelerated. 2 The fan blades are angularly deformed, and the limited damper is not opened, depending on the situation. 3 The nozzle shaft in the ultra-low volume nozzle is bent, and there are debris or serious wear in the high-pressure jet nozzle. Take appropriate measures to deal with it.

There are three main types of Rice.

In GB/T 1354-2009 "Rice National Standards", there are only three types of rice: glutinous rice, glutinous rice and glutinous rice.
Pick rice three steps

Look

Packed rice first look at whether the packaging is marked with QS mark, product name, net content, production date and shelf life, quality grade, product standard number and other information.

Look at the color and size of the rice grains in bulk to see if there are broken rice or yellow grains.

smell

Premium rice has a natural valley scent and no smell.

taste

New rice has a higher protein content and is harder than Chenmi.

Other Rice

Royal Basmati Rice,Nutritious Rice,Medium Grain Rice,Short Grain Rice

Ningxia Saiwaixiang Food Co., Ltd. , https://www.nxswxfood.com