Our Honde brand offers outstanding value and performance for your farming equipment needs. We specialize in the design and manufacture of Pig Feeding Systems in a variety of shapes and styles, but the main product is the feeding pan. Our Pig Feeding Systems are all made of high quality stainless steel. The Pig Feeding Systems can be used for piglets or pigs. Pig Feeding Systems can not consume too much food due to its depth and depth. Pig Feeding Systems products can hold water or wet food, and will not rust, is conducive to the health of pigs. All Pig Feeding Systems products have rounded and smooth pan edges to prevent pigs from being harmed during use. Our Pig Feeding Systems make farming easier and easier to operate, and pigs will enjoy our pig feeding systems.
Pig Feeding Systems Pig Feeding Systems,Pig Equipment Automatic Feeding System,Pig Feeding Pan,Auto Feeding System For Pigs HuangHua FengYi Honde Metal Factory , http://www.farrowingcratesfromchina.com
2. After the crusher is installed, check the tightening conditions of the fasteners. If loose, tighten them.
3. To check whether the tightness of the belt is proper, whether the motor shaft and the shredder axis are parallel.
4. Before starting the crusher, first turn the rotor by hand to check whether the claws, hammers and rotors are flexible and reliable. There is no collision phenomenon in the shell. Whether the rotation of the rotor is consistent with the direction indicated by the arrow on the machine, the motor and the powder The lubrication of the machine is good.
5. Do not easily replace the pulley to prevent the speed of the crushing chamber from exploding, or the speed is too low to affect the work efficiency.
6. After the crusher starts up, it will idle for 2 to 3 minutes. No abnormal phenomenon will occur after the crusher is started.
7. Always pay attention to the operation of the pulverizer during work and feed it evenly to prevent obstruction of boring cars. Do not overload for a long time. If there is vibration, noise, high temperature of the bearing and the body, spraying of material outside, etc., it is necessary to immediately stop the inspection and remove the fault before continuing to work.
8. The crushed material should be carefully inspected to avoid accidents such as copper, iron, stones and other hard objects entering the crushing room.
9. The operator should not wear gloves, and should stand on the side of the grinder when feeding so as to prevent rebounding debris from injuring the face.
10. Forbidden to feed or withdraw feed by hand or wooden stick when jammed.
The correct use of feed mills
1. The long-term operation of the crusher should be fixed on the basis of cement. If the working site is frequently changed, the shredder and the electric motor must be installed on the base made of angle iron. If the shredder is powered by diesel, the power of the two should be matched, that is, the diesel power is slightly greater than the shredder power, and the two are The pulley groove is the same, and the outer end face of the pulley is on the same plane.