Osmanthus twig cutting cutting seedlings

Osmanthus is a deciduous tree evergreen tree. The branches and leaves are green and graceful. They are fragrant and fragrant when the flowers are open, and are fragrant and fragrant. The flower is edible and refined. It is an important garden and economic tree species in China and has high ornamental and economic value. Osmanthus fragrans because of few seeds and difficult to obtain, grafting is not ideal, so the use of cutting propagation, which uses tender shoots cutting seedlings, easy to draw, easy to operate, high survival rate, now introduce its technical points for reference.
1 Cutting time should be from mid-May to mid-July and mid-September to mid-October. At this point, the shoot has stopped growing, and the branches contain more nutrients. The branching ability of the branches is strong, and at the same time, the temperature is suitable, and rooting is easy after cutting.
2 The preparation of the cutting bed should be used as a nursery ground for the light loamy cultivated land of rice. Deep plowing beds require a bed width of 120cm, a bed height of 25cm, and a ditch width of 40cm. The soil should be finely crushed, the bed surface should be flat, and the channel should be open. On the insert bed, cover the plastic film arch 50cm high above the bed, and then cover the shed with a height of 180cm above the bed and a light transmittance of about 35%.
3 The cuttings were selected and grew vigorously. The superior plants without pests and diseases were the mother trees of the cuttings. The upper part of the periphery of the canopy was cut with semi-lignified twigs for scion. The scion should be bundled into small pieces at the calibrating level, and the base bag should be brought back to the room with wet toilet paper.
4 Cuttings Cutting the cuttings into 8-10 cm lengths, leaving 2 leaves cut in half; the upper end is cut into flat mouths, the base is cut into bevels, bundled into small handles, and the part 3 cm below the base is immersed in 5105 naphthaleneacetic acid or 110-4 ABT rooting powder solution immersed for 1 hour, then remove the cuttings.
5 Cutting operation The cuttings should be cut in diameters (sections) by diameter. With a row spacing of 510 cm, first insert a rough wooden pick on the insertion hole and insert the lower 2/3 of the cutting into the hole to compact the soil around the cutting. Finally, a 0.01% carbendazim solution was sprayed through the bed for 1 time to disinfect the soil and provide moisture.
6 Post-insert management
6.1 When water-spraying and shading film dry water-free beads and bed soil, it should be sprayed with moisture. The high-rise shade awning is covered with a cover in the morning; the relative humidity in the membrane shed should be kept above 85%, and the temperature should be controlled at 18-30°C. If the temperature is too high and the humidity is too low, it can be adjusted by removing the cover material and increasing the water spray. If the temperature is low and the humidity is too high, it can be controlled by closing the membrane and reducing the water spray.
6.2 spray spray and loose soil combined with water, spraying 510-4 carbendazim solution once every 7 days 1 times to prevent cuttings infected with bacteria caused by cortex decay. Loosen the bed frequently to maintain good permeability of the soil and prevent the decay of the cutting roots due to lack of oxygen.
6.3 Applying buds and fertilizers must promptly eradicate the germination of the cutting base to reduce nutrient consumption. In combination with water spray, 0.2% urea or potassium dihydrogen phosphate solution was sprayed once every 10 days to promote root and shoot growth.
6.4 Demolition sheds can be removed in the summer of October when the sheds are removed and transplanted. Daejeon nursery can be transplanted in Hunchun. Autumn sheds can be removed in the spring of the following year in the autumn and transplanted to the Daejeon nursery in early summer. The summer and autumn plugs can be kept in bed for 1 year. The following winter seedlings can be as high as 30-50 cm. They can be planted in gardens or cultivated in gardens.

Character:

Variety type:  Early maturity chives  variety
seeds type: hybrid chinese Chives Seeds
Maturity: About 38 days after sowing
Leaf color:  Green
Sowing dosage: 1.8 to 2kgs/667m2
Best growth temperature:

15 to 32 degree

Planting season:   Seasons, according to the local climate
Application: Open air or greenhouse
Size:

About 20cm length

Other: 

The generation hybrid chinese chives seeds, good flavor and commodity, suit for seasons planting.


 

Cultivation point: 

Plant space Planting season The grow temperature
10 to 20cm According to the local climate 15 to 32 degree

Chives Seeds / Small Leek Seeds

Chives Seeds,Small Leek Seeds,Early Maturity Chives Seeds,Hybrid Leek Seeds

Ningxia Zhongqing Agricultural Technology Co. Ltd. , http://www.zq-vegetableseeds.com