The quality of agricultural vehicle running-in has a significant impact on the power, economy, reliability and service life of agricultural vehicles. Therefore, the following requirements must be met. Reduce the load. During the running-in period, the load of the agricultural vehicle shall not exceed 80% of its rated load, and trailers or other implements shall not be towed. Within the first few tens of kilometers of use, it is best to empty the air and gradually increase the load. The gear used for driving under various load capacities must be raised from low to high, and the gears must be run in. The common gears must be used more frequently. Control the speed. The maximum speed of general agricultural vehicles should not exceed 40km/h, and the speed limit device must not be removed at the same time. Control engine operating temperature. When the agricultural vehicle is running in the winter, the engine should be warmed up to above 40°C before starting. During driving, the temperature of the cooling water should always be maintained in the range of 75~95°C. Select high-quality fuel and lubricants. During the running-in of agricultural vehicles, diesel with high cetane number and low viscosity, good quality lubricant should be used to improve the lubrication conditions of various parts and to prevent the engine from working rough. Use good roads. Agricultural vehicles should not run on poor roads during the break-in period, and should not climb over steep slopes to reduce the vibration and impact of mechanical parts and prevent excessive load. Do not start the engine and stop the throttle when it is parked. Begin and accelerate slowly. Change gears in a timely manner. Avoid emergency braking as much as possible. Strict implementation of maintenance requirements during the run-in period. In order to ensure the quality of running-in, before the start of running-in, the entire vehicle should be cleaned, and the various parts of lubricant, grease and special fluid should be inspected and replenished to check the fasteners of each part. After driving for 500km, clean the engine lubrication system and the chassis gearbox and replace the lubricant; add lubricant to the entire vehicle lubrication point, check the brake performance and the technical condition of the piping and fasteners of each department, and tighten as necessary. Solid and adjustment; tightly fix the cylinder head and the bolts and nuts of the intake and exhaust pipes, check and adjust the valve clearance. Co2 Breathing System,Breathing Therapy System,Anesthetic Breathing Systems,Disposable Ventilator Anesthesia Breathing System Zhejiang Hisern Medical Technology Co., Ltd , https://www.hisernmedical.com
Agricultural vehicle run-in period requires
Blocking particles, bacteria and other pathogens in Anesthesia and breathing circuit from
entering the respiratory system