Using EM cultures In the breeding process of alfalfa, the fermentation process of alfalfa feed (poultry, lees, bagasse, remaining meals, waste blood, and animal internal organs, etc.) is the key. If the feed is not fermented or the fermentation is incomplete, harmful gas will be produced, and the pH may be too high or If it is too low, it may cause the cockroach to escape, not produce or even die. Using EM stock solution to ferment fecal material, the fermentation time of the feces material is greatly shortened and the odor is reduced. After the feed is fermented, the pH value will naturally reach 6.5 to 7.5. Without adjustment, the feed can be directly fed, and the feed utilization rate is greatly improved.蚯蚓 蚯蚓 蚯蚓 茧 , , , , , , , , ç¹æ®– ç¹æ®– ç¹æ®– ç¹æ®– ç¹æ®– ç¹æ®– ç¹æ®– ç¹æ®– ç¹æ®– ç¹æ®– ç¹æ®– ç¹æ®– ç¹æ®– ç¹æ®–. Methods as below: Use straw and straw (better cut) to lay a layer of dry material (10 to 15 cm thick) on the dry material and spread the material on the dry material (4 to 6 cm thick). Repeat this process for 3 to 5 layers. One layer is sprayed with a spray bottle (EM raw liquid is added to the dung heap at this time, one ton of manure needs EM10 kg to dilute about 100 kg of water) until the water seeps out as well; if rubbish is used, a layer of rubbish layer is used. Manure, length and width is not limited, and cover the film with strict; if you use 100% fecal material, the first sun dung to the fifty-six percent dry after the pile, immersed in water with EM, covered with film. Second, turning In the season where the temperature is higher, the temperature in the reactor generally rises on the second day of the plant. It can rise to 60°C to 70°C in 4 to 5 days, and then gradually decreases. When the temperature in the reactor falls to 40°C (this process requires 12 Day) Turn over the top, turn the top down, turn both sides to the middle, and add the EM diluent. In winter, it is turned 2 or 3 times and it is turned over in summer. Third, feeding After the feed fermentation is finished, the feed water can be used immediately after being heated to disperse heat. Generally, the method of feeding and feeding is commonly used in feeding, and the method of feeding is used to cover the feed that has been eaten by the fish, every 10 to After 15 days, the side feeding method is to take out a portion of the finished feed and add the new feed to the side, and add the other side next time. Polymer Coating,Seed Coating Adjuvant,Seed Coating Polymer,Seed Coatings Jiangxi Tiansheng New Materials Co.,Ltd , http://www.jxtsxcl.com
One, rack reactor