Small harvesters should pay attention to the following points when using and maintaining: 1. Before harvesting, first combine the power transmission with the machine so that the empty car can be tested for a few minutes to observe whether there is any abnormality. 2. After the tractor lands, it should be started steadily and run straight. When it is received, it is not necessary to turn off the table to avoid missed cuts. 3. When harvesting fallen crops, wheat is generally better harvested in reverse. If harvesting is difficult, one-way counter-falling harvesting or harvesting perpendicular to the lodging direction can be used. For rice, harvesting can be done with one-way falling down or perpendicular to the lodging direction. 4. When the harvester malfunctions or the crop is blocked, check it after stopping and turning off. It is strictly prohibited to fiddle with the parts on the harvester or troubleshoot without stopping, so as to avoid human-machine accidents. 5, when received, according to crop height and density, the appropriate choice of tractor walking speed. Generally, the crops grow well and are dense, and the speed should be slow to prevent the harvesters from being blocked; the poorly growing crops can be faster. 6. When the harvester turns, wait until all the cut crops have been exported, then reduce the slow turning of the throttle. 7. After reeling for 2 hours, the bearing should be lubricated. After 10 hours of operation, all lubrication parts should be lubricated. 8. During the harvesting process, attention should be paid to observing the field conditions. If there are bricks, stones or other hard objects, they should stop immediately and move them away to avoid damaging the cutter. 9. After each operation of the harvester, the header should be landed on the ground to remove the dust, Burmese grass, mud and grass between the knife and the pressure of the harvester, and add the oil. 10. The reel wheels of small-sized harvesters are mostly made of hard plastic. If they are deformed or broken, they can be repaired by the hot-calendering method and the adhesive method. Blasting This is the twisted deformation of the wheel point, placed in the boiling water to soak or bake on the fire until the turn point becomes soft, the wheel point pad cares on the board, and then add on the wheel point - flat pressed hard to restore As it is. Adhesive method is to first break the hair, and then the breakpoint with 60-type adhesive glue, according to the original fracture alignment, tight, 24 hours after use. 11. After the harvest season is over, perform a complete maintenance and repair of the harvester. Wash and remove the parts of the machine and inspect the parts for damage or deformation. Check whether the lubrication of each lubrication area is adequate. Apply anti-rust oil to the cutting and stripping parts. Finally, store the whole unit in a ventilated and dry place for use in the next year. Fd Vegetables And Fruit,Freeze Drying Spinach,Dehydrated Fruits Vegetables,Fruit And Vegetable Food Dehydrated Xinghua Dongbao Foods Co.,Ltd , https://www.xhdongbaofoods.com