Corn Combine Troubleshooting

Before the “three autumns” approach, agricultural machinery drivers should conduct comprehensive technical maintenance on the units in time before they go out. This will enable the units to maintain a good state of technology, reduce malfunctions, increase operating efficiency, and extend the service life of the engine; if the operation encounters sudden When you fail, don't panic, I introduce the following troubleshooting methods for you:

1. If the normal operation encounters severe engine vibration, the driver should immediately stop the operation. Open the vehicle to an open area. After getting off the vehicle, first check the looseness of the cross bearing or tightening bolt of the drive shaft of the vehicle, and confirm that it is a cross. When the bearing is damaged, the new part should be replaced. If the fastening bolt is loose, tighten the bolt with a torque wrench to work.

2. If the spindle temperature of the chopper is high during operation, the driver should stop the work and get off the vehicle to check whether the lack of oil or the v-belt is too tight. Check the lack of oil and inject the oil; if the belt is too tight At this time, the tightness of the reel chain should be adjusted immediately.

3. If noise is heard from the transmission during normal operation, the operation should be stopped. Get off the vehicle and check if the gear backlash is not suitable. If the gear or bearing is damaged, adjust the backlash to 0.15~0.35 mm or replace the bearing. run.

Forehead Thermometer

Shenzhen urion Technology Co., Ltd. , https://www.urionhealth.com