Causes and Remedy of Various Malfunctions of Small Motorized Sprayer

1. Can not start or start difficult reasons and troubleshooting: 1 oil tank, no oil, plus fuel can be; 2 the oil roads are not open, should clean up the oil channel; 3 dirty fuel, oil, water, etc., need to replace the fuel; 4 Into the cylinder too much oil, remove the spark plug a few laps and dry the spark plug can be dry; 5 spark plugs do not flash, excessive carbon deposition or insulator breakdown, should remove coke or renew the insulator; 6 spark plug, platinum interval Improper adjustment, should be re-adjusted; 7 The capacitor is broken down, the high-voltage wire is damaged or dissociated, the high-voltage coil is broken down, etc., must be repaired and renewed; 8 The white gold is oily or burned, the oil is removed or the burned part can be polished. ;9 The spark plug is not tightened, the crankcase leaks, the cylinder gasket is burned, etc., the relevant parts should be fastened or the cylinder gasket should be replaced; 10 The self-tight oil seal on both sides of the crankcase is seriously worn and should be replaced; The main air valve is not open, open You can.

2. The reasons for starting but lack of power and how to eliminate them: (1) Insufficient oil supply, main volume hole plugging, air filter plugging, etc., should be cleaned and dredged; 2 Platinum clearance is too small or the ignition time is too early; 3 should be adjusted; Room too much carbon deposition, so that the mixture gas preheat phenomenon (characteristics of the body temperature is too high), should remove coke; 4 cylinder liner, piston, piston ring is seriously damaged, should replace the old parts; 5 mixed oil is too thin, should Improve its contrast.

3. Reasons for the unsteady operation of the engine and troubleshooting methods: (1) The main parts are worn badly, and there is a knocking phenomenon in the movement. The main parts should be replaced; (2) The ignition timing is too early, there is a phenomenon of tempering, and adjustment must be made after inspection; 3 Platinum wear Or loose, should update or tighten the platinum; 4 float chamber with water or deposited oil, causing the operation is not smooth, cleaning can be.

4. Reasons for sudden flameout in sports and how to eliminate them: (1) When fuel is burned, refueling should be completed; (2) High-pressure lines should be removed and connected; (3) Throttle control mechanism should be disassembled and should be repaired; (4) Spark plugs must be broken and must be replaced.

5. Pesticide spraying does not atomize the reasons and exclusion methods: 1 low speed, acceleration can be; 2 fan blade angle deformation, installed a limited damper is not open, ultra low nozzle nozzle shaft bending, high pressure jet nozzle If there is any debris or serious wear, corresponding measures should be taken to deal with the above-mentioned causes of the malfunction.

Spine Internal Fixation Series

Lumbar Vertebra Fixation,Orthopaedic Spine Implants,Horacic Vertebra Fixation,Vertebra Lumbalis Surgery

Jiangsu Health Medical Technology Development Co., Ltd. , https://www.medicalhos.com